Exp-computer CDG Game Upgrade User Manual

GAME PORT UPGRADE KITFORPORTABLE CD-ROMINSTALLATION MANUALCDG-GAMECDG-IDE/G

APPENDIX CENABLING 32-BIT CARD SUPPORT OF WINDOWS 95Your system should be ready for PCMCIA socket support prior to operatingthe CD-ROM and Game Port.

APPENDIX DPCMCIA SOFTWARE(DOS/WINDOWS3.X) INFORMATIONIf you have installed the PCMCIA software, such as SystemSoft’s CardSoft orDatabook’s Cardtalk, t

SYSTEMSOFT PCMCIA SOFTWARE SAMPLE CONFIG.SYS FILELASTDRIVE=ZDEVICE=C:\DOS\HIMEM.SYSDEVICE=C:\DOS\EMM386.EXE NOEMS X=D000-D3FFFILES=40BUFFERS=20STACKS=

INTRODUCTIONThe Game Port upgrade kit for EXP CD-ROM has two different configurations- •• the CDG-GAME and the ‚‚ CDG-IDE/G. If your CD-ROM kit wasequ

INSTALLING THE CD-ROM WITH THE GAME PORT ADAPTER1. Connect the game adapter to your CD-ROM drive, and tighten the twoscrews on the game adapter. 2. Co

NOTE:1. INSTALL.EXE is only for DOS/Windows 3.x Mode, DO NOT use it underWindows 95, unless you want to use this device under pure MS-DOS.Please see A

SOFTWARE INSTALLATION FOR WINDOWS 95The following dialog box will appear when you are using the CD-ROM+ cardunder Windows 95 for the very first time.I

REMOVING OR RE-INSTALLING THE DEVICE DRIVERYou can always change your configuration by removing the driver andreinstalling again. To remove the driver

GAME-PAD CONTROLLER DESCRIPTIONNOTICE1. The I/O address 200-207 of your computer must be available, or theGame port will not work properly.2. It is

APPENDIX BThis procedure will allow you to use the device in a pure MS-DOSenvironment for those applications that will not run in Windows 95.An MS-DOS

• Click on the "Advanced"• Click the "MS-DOS mode"Click on "Specify a newMS-DOS configuration"• Click on "OK".